I have a carb. to put on a 1985 honda 200s.
Can someone pls tell me where the hoses go. I have gone through 212 pages of a manual with no luck. All I see is one hose from petcock to tank, where do the other 3 go?
Thanks,
Registered User
New to the board
carburetor help
I have a carb. to put on a 1985 honda 200s.
Can someone pls tell me where the hoses go. I have gone through 212 pages of a manual with no luck. All I see is one hose from petcock to tank, where do the other 3 go?
Thanks,
Power User
Lord of the trike
The one on the bottom of the float bown is the drain/overflow hose. The hose on the side where below the throttle slide is a overflow/vent. Where is the 3rd hose?
1984 Yamaha YT 60 Tri Zinger(current project)
1983 Yamaha YTM 200 (rear suspension kit)..... long term project
2004 BMW R1150R
1972 Honda CT 70
2007 Lifan 110
Registered User
New to the board
Okay, so right there are only 3.
So the other 2 just hang there? does the longer hose go on the vent overflow or on the bottom of the bowl?
Thanks so much for helping me!
Power User
Lord of the trike
I think the longer one goes on the drain (bottom of the float bowl). I will have to double check though.
1984 Yamaha YT 60 Tri Zinger(current project)
1983 Yamaha YTM 200 (rear suspension kit)..... long term project
2004 BMW R1150R
1972 Honda CT 70
2007 Lifan 110
Just Too Addicted
Arm chair racerJust too addicted
longer one def goes on drain, shorter one is ment for overflow, and on some choke assemblies actually fits into place to direct it away from the engine
Current Project:1978 Pontiac Phoenix 355 v8
Past Bikes: 1999 Yamaha Big bear 350, 1981 Yamaha XS 400, 1996 Yamaha yz250 1984 Honda big red, 2004 Xtreme cr107, 1999 Yamaha bear tracker, 1999 Suzuki ds80 STOLEN, 2005 Kawasaki klx110, 1986 Honda trx200sx
Daily Driver: 1990 Buick Electra Park Avenue 3.8 v6
Reply With Quote