Another Axle ID Request

[sjsst41]

Got this axle with the ‘85 Tecate I purchased, assuming it was a spare & I can confirm it’s not. Pics show dimensions. The major difference is the larger OD where the bearings sit.

Any feedback is appreciated.

Steve

[sjsst41]

So approximately 40 mm on the bearing ID that would be used on this axle.

[Footy]

do the hubs in the photo fit the axle?

[atc300r]

It could be a Honda axle 85-89 250r, 400ex, 350x, 450r, use a 40 mill inner race .Also Suzuki Quadracer and Quadsport has 40 inner race size.

[sjsst41]

do the hubs in the photo fit the axle?

They do fit that axle

[sjsst41]

It could be a Honda axle 85-89 250r, 400ex, 350x, 450r, use a 40 mill inner race .Also Suzuki Quadracer and Quadsport has 40 inner race size.

Initially thought maybe a 250R, but the hub bolt spacing is much larger than what’s on a Honda (I have an ATC250R and was comparing). Maybe a Quadracer? I’ll do some more investigating. Thanks !

[Footy]

Exactlly! The hub is something like 4 on 156mm. I think that is the bolt pattern for a 1990 model yamaha Banshee.
I do not know the bolt pattern for the quad racer but I have a friend with a 1985 model so I can find out.

[sjsst41]

Sounds like an early Banshee then, I see the Suzuki QR is 4 x 130 mm (via web search).

[Footy]

Sounds like an early Banshee then, I see the Suzuki QR is 4 x 130 mm (via web search).

Yes my friend with the 85 model said that as well.
I think 1989 and 1990 banshee used 4 on 156 rear hubs.
Also the polaris scrambler 400 & 500 and 2003 predator 500.

[sjsst41]

What’s odd is looking at ‘89 & ‘90 Banshee hubs don’t look like the ones I have:

[Red Rider]

What’s odd is looking at ‘89 & ‘90 Banshee hubs don’t look like the ones I have:

From your post #1, you have what appear to be Tecate hubs. The hubs pictured in post #10 are indeed Banshee hubs. Both of the hubs in question have the same spline count, and will work on either axle.

[sjsst41]

Got it - Thank you for clearing that up.