2006 Suzuki LTR450 swing arm

[HK1837]

Hi guys

Does anyone have one of these they can measure for me? They are steel I believe?

I'm looking for the width:

Across the pivot.
Across each side where the bearings go.
Distance in the middle where the engine goes.

I cannot find any locally (in Australia) to measure and want to check one will work for me prior to buying from the USA with lots of $ freight.

[HK1837]

I found one, in New Zealand of all places. It looks like the LTR swing arm is the same measurement across the engine at the pivot, but its about 6-7mm wider on the outside than the DRZ frame. I think it might be the same width as an RMZ. In any case it will fit with some mods.

[oldskool83]

hreatv.com has stock ones. he builds all kinds of reproduction parts and custom ones. It might be easier for you to order a custom swinger for your project. Most times partzilla.com will list bearing sizes or bearing / seal numbers and you get can measurements in MM by looking / searching the bearing sizes.

[HK1837]

Thanks mate. The initial build will probably be a trial and I'll get hreatv to build me one properly once its all sorted.