Correct clutch pattern

[Tortuga]

1980 Honda ATC 110: Took apart my clutch and it was in this arrangement for the metal plates

https://ibb.co/h8pJSP8

But according to a Youtube video AND this schematic it appears #1 and #2 should be switched.

https://cdn.partzilla.com/cdn-cgi/im...g-93bfee37.png

Which one is right? Or am I viewing the schematic incorrectly?

EDIT: #1 in reference is towards engine

[shortline10]

It doesn’t matter if it’s 1 or 2 that go in first , just don’t locate the holes where there depressing the springs . The only steel plate that pushes on the springs is the last plate .
That middle plate would be for a clutch setup that had the short middle plate springs which doesn’t apply to your clutch .
Hopefully I explained it correctly lol .

Just looked at the partzilla diagram , do you have the short middle springs ?

[Tortuga]

Yes I have two short middle springs.

[shortline10]

Then the # 2 plate was assembled correctly .

[Tortuga]

Awesome thank you so much