300ex Rear Fenders on '86 200x?

[rodeofan5656]

ive found little bits of info on this subject, but never found a yes or no for the question- will 300ex rear fenders fit directly to a 200x? not sure what i wanna do for fenders yet, but im tryin to increase my knowledge. thanks to anyone with advice!

[bucko]

Im not sure.I know the trx fenders fit.I had a set on my 86' X.Similar to this one http://www.ebay.com/itm/Honda-250R-O...item19cd2bc400

But the part where it meets the gas tank doesn't connect smoothly and there's a gap.

[rodeofan5656]

were the bolt holes already lined up, or did you have to drill your own? do you have any pictures of the fenders on your trike? thanks

[bucko]

I had to drill them but it was pretty easy.

[rodeofan5656]

hey! i saw that on eBay! you were sellin that along with a tecate. i read that you decided to keep em and didnt know how to delete the auction haha

[bucko]

Yup hahaha .It wouldn't let me it would just say ''this action cannot be performed with this auction''

I did end up selling the 86'x but I kept the tecate.Just going to restore it slowly.

[rodeofan5656]

do you remember what year TRX those fenders came off of? and do the fit right down on the frame just right, other than havin to drill holes?

[bucko]

do you remember what year TRX those fenders came off of? and do the fit right down on the frame just right, other than havin to drill holes?

All I had to do was drill the holes.Fit on the frame no problem.I cant say for sure what year they were from but they look very similar to the one in the link I posted.

Just about any 200cc-400cc atv fenders will fit it as long as there is enough room(plastic surface) to drill the mounting holes for the seat.
And as long as the top where the seat mount is flat like the stock fender or like the trx fender in the link.

My buddy had a 400ex rear fender on his 200x.

[rodeofan5656]

ok, thanks a bunch for the info. that clears alot up for me. now, time to get the rest of the trike fixed and start savin for some fenders. thanks!

[Dirtcrasher]

Unless you have access to other models cheap fenders, whats the point? They don't fit right, they need drilling and the seat doesn't match up.

Get a set of MAIERS and be done with the best fit/finish available these days.......

[JJMF1979]

Unless you have access to other models cheap fenders, whats the point? They don't fit right, they need drilling and the seat doesn't match up.

Get a set of MAIERS and be done with the best fit/finish available these days.......

Ya I even have a brand new in the bag 86 200x rear maier fender I offered to sell him for $120 plus ship because it came with my 83 200x and won't line up perfectly with the tank.....but maybe he wants to get a more custom look

[rodeofan5656]

If i knew then what i do now, and had the money, i woulda been all over that offer! Wish i could get that kinda deal now haha

[TriMotoMan]

if you weld a couple tabs on your frame you can run 400ex fenders fairly easily, also the 200x seat doesn't look to bad on it, i've done it twice with good results

[TriMotoMan]

one 200x has a 250 chinese motor I transplanted and the other has an 83 cr480 engine I put in

[TriMotoMan]

the red one is in stock position and the white one is stretched so the fenders are further back