PDA

View Full Version : ATC200s, can't get the stator off!!!


Serious Tim
06-04-2009, 08:16 AM
Trying like hell to get the stator magnet assembly, flywheel, whatever you call it off, and it wont budge! The nut is of course off, and I'm using a puller with threaded bolts into the assembly as it should, but I'm cranking the thing as hard as I can, and it's not breaking free. Help! :wondering
mmiguy2103
06-04-2009, 08:45 AM
use a impact gun, with at leat 200 ft lbs of tourque. it will come off with no problem!
Serious Tim
06-04-2009, 08:48 AM
I did one of these on a 225dx not two weeks ago, and I was able to break it by hand. It's really on there THAT hard??
rdlsz24
06-04-2009, 10:00 AM
Crank the puller as tight as you can get it, and then whack the end of the puller bolt that is against the end of the crank with a mini sledge. Repeat until it pops off.

Rob
AutoXer
06-04-2009, 10:04 AM
should just have a puller that screws into the center and pushes on the crank I just did 2 of these one was tight but not to bad ... I think a axle is threaded right if you don't have a proper puller . Do a search to verrify
Serious Tim
06-11-2009, 06:01 PM
Finally got the stupid thing off.....used a different puller and an impact....and a couple Budweisers :)

Now, the replacement spark source coil doesn't look exactly like either one on the stator. Is the spark coil the one on the top (smaller) or the one on the bottom (larger)?

Thanks guys!
Serious Tim
06-12-2009, 08:11 PM
Anybody? :(
CRAZY70MAN
06-12-2009, 09:30 PM
get ya' a large rubber mallet next time, rap it all around,,,, really helps with the stubborn flywheels............
hublake
06-13-2009, 06:26 AM
Finally got the stupid thing off.....used a different puller and an impact....and a couple Budweisers :)

Now, the replacement spark source coil doesn't look exactly like either one on the stator. Is the spark coil the one on the top (smaller) or the one on the bottom (larger)?

Thanks guys!

Just did the same thing. It is the one on the top.
Howdy
06-13-2009, 06:49 AM
Finally got the stupid thing off.....used a different puller and an impact....and a couple Budweisers :)

Now, the replacement spark source coil doesn't look exactly like either one on the stator. Is the spark coil the one on the top (smaller) or the one on the bottom (larger)?

Thanks guys!

The exciter coil is the smaller one, the larger one is your lighting coil.
Howdy