250sx help

[Jbird5363]

M trying to get my new toy started I cleaned the carb out it is nice and clean all new gas lines and I sand blasted the inside of the tank there shouldn't be any fuel issues when I try to kick start it it takes like 20 or more kicks to get to the compression cycle it sparks when it hits this cycle but it takes forever I tried to jump start it but no good I replaced the fuse and still no juice to the dash board any ideas

[peco250sx]

sounds like electrical, get yourself a multi meter and start doing resistance and voltage drop tests between the starter and the battery and between the battery and the dash.

[Jbird5363]

I have a multi and a power probe I was thinking of doing the voltage check with the probe I don't even know where to start on this thing I'll get my pops to help he is pretty sharp with wires
Thanks for the help

[rugabugadouglas]

if your kicking and kicking with no compression your clutch bearing for the kick start is prob bad then

[Jbird5363]

We taped on the shaft and it catches I'm going to take that case cover off and see what's goingbon in there