Can anybody build extended swingarms?

[kilabeez0]

I would like one for my 200x. They dont seem to difficult to fabricate. Anyone ever done this?

[MR ATC]

yes i can do them. i charge 150.00

[MR ATC]

or for 650.00 you get one like on the bottom made out of aluminum. (the top is a stock 350X)

[kilabeez0]

so for $150 you'll extend a factory one and for $650 you'll build one out of aluminum? Those seem like great welds I have to admit, a bit steep on price though. How long does it take you to do it?

[MR ATC]

about a two week turnaround. yes 650.00 is steap but most of the other swingarm builders charge 550.00 for chromoly swinarms that they sell regulary and 650.00 for custom aplications like yours and their still chromoly. Aluminum is more expensive.

[sand45]

Im also going to make one out of aluminum for my 350x. I made a couple of swingarms for the ds650. One aluminum and one steel. :-D

[samster143]

Mr ATC,

If that is your handywork.....I'm impressed!

[MR ATC]

i designed and fabricated the pieces but can't take credit for the welding it was done by my consultant/welder Denny.

[Dan Tenn]

can you say beefy, wow!! Nice work :shock:

[samster143]

After welding, are the swingarms heat treated?

[KASEY]

thats a good question,,,, stress revieving is very important on something with that much welding especially aluminum which expands and contracts much more than steel when welded,,,