200x questions

[oscarmayer]

84 200x, (not confirmed it's an 84. here's the vin, can some one check?)
JH3TB0525EC323101

will the Swingarm Pivot Bolt from a 1985 Honda 200X fit the one I have?
Whom makes swing arm rebuild kits?
I am going to need the following immedeatly.


on/off switch assembly
front brake lever setup (master resivore is trashed and i beleive the cyclinder is probelby shot (unless there's a rebuild kit for it)
new clutch and any other cable
new brake pads
new plug
new rear bearings
new swing arm bearing setup
rebuild carb
new fuel pecock

[SWIGIN]

all 83-85 parts interchange

[oscarmayer]

SWEET!!!! TY sir!

[oscarmayer]

where can I get a rear shock rebuild kit?

[dan440hemi]

if you find one can you pm me with details?

[SWIGIN]

no kits that i know of but i have a site saved on my ps3 that sells TONS of factory shock parts.

no part numbers though since i guess they are straight from showa and not honda, but they have the measurments so all you need to do is measure you seals and bushings and your set.

i'll get it for you later.

[SWIGIN]

www.moto-pro.com

[oscarmayer]

sweet thanks!

I'll cotnact them and get details on what they need. then I'm gogin to tear my shock down and get a listing of parts. once I have that listing and can get a matching setup from them, I'll work onseeing if they can be offered as kits.

[dan440hemi]

ok sounds sweet cant wait thanks!!

[Saul]

I also have a quick 200x question - anyone make a rear sprocket bigger then 40 teeth to fit 83-85?

[oscarmayer]

hrmm not sure. if I find one, I'll let ya know.

[dan440hemi]

i have in seen any thing bigger than a 40 i dont think so

[Saul]

I ordered a 40 tooth anyways - gunna offset it with a 12 tooth front.

I should be at a 3.33 gear ratio.

[BigRed_Ryno]

I also have a quick 200x question - anyone make a rear sprocket bigger then 40 teeth to fit 83-85?


Why not just go a tooth (or two) smaller at the front?