needing good jug for poor kid's project.

[oscarmayer]

the jug someone donated seems to be bad. :( it's ok at least we tried.

i am in need of a good jug stocker size. i have a nearly new piston and ring set in stock size. i jsut need a good jug.

if oen of you have a good jug you can donate, please let me know. if i need to send $ for shipping i'll do it, but please ensure it's a good jug. every $ counts on this build.

[Vealmonkey]

I doubt that you will find a jug in good enough shape to use the stock bore piston and rings in. You would be better off looking for the first oversize piston and rings.

[thefox]

What machine was this for again?

[SYKO]

85 125m.........

[snowwolf]

i know where there is a 110 dont now if it runs or not but i can see if the guy whants to sell the moter if youwhant me to

[oscarmayer]

thanks man. i have like 2 or 3 110 jugs. does anyone know if they will work with the 125 if bored to stock 125 size?

if it will then i'll fork the $50 over for boring and honing.

[Vealmonkey]

You would have to compare the lower part of the cylinder sleeve where it fits into the engine casings. If the outside diameter of the sleeves is the same, then it should work. You have both the cylinders don't you? Get comparing and let us know if it works.

[fabiodriven]

I doubt that you will find a jug in good enough shape to use the stock bore piston and rings in. You would be better off looking for the first oversize piston and rings.

Never say never. There could be one kickin around out there that could just use a quick hone-

[oscarmayer]

hehe, i will have to pull a 110 jug. will do that this weekend.

hopefulyl someone has a 124 jub though in good shape. would be easier.