roger86200x
09-14-2008, 11:33 AM
http://i355.photobucket.com/albums/r449/roger200x/headdowel.jpg
In this pic I have circled a dowel position in the head...
I found a broke off bolt in this hole and drilled it out. ( I found if AFTER I had the head work done! :mad: )
Anyways, I need to know if oil really flows through that particular dowel or if its just used to align the top piece/rocker head onto the head itself... the one in the back of the engine is used if I remember right...
I have 2 old heads that are destroyed but that bolt hole was fine... so I put 125 psi of air pressure into that hole and it went NOWHERE....I thought it went UP then, but after looking at it thats not the case either... I just want to make sure im right...
Is there an oil path "map" of the 86 200x?
Roger
In this pic I have circled a dowel position in the head...
I found a broke off bolt in this hole and drilled it out. ( I found if AFTER I had the head work done! :mad: )
Anyways, I need to know if oil really flows through that particular dowel or if its just used to align the top piece/rocker head onto the head itself... the one in the back of the engine is used if I remember right...
I have 2 old heads that are destroyed but that bolt hole was fine... so I put 125 psi of air pressure into that hole and it went NOWHERE....I thought it went UP then, but after looking at it thats not the case either... I just want to make sure im right...
Is there an oil path "map" of the 86 200x?
Roger