BigRed_Ryno
08-10-2008, 12:24 PM
I'm in the process of putting a '84 200s motor into an '85 200x roller. Firstly i only have the mounting brackets for the 200s, which ive found are different to the 'x' frame, this isn't too much of a problem as i can fabricate some bits at work. what's really got me stumped is the wiring, the CDI from the 200s plugs right into the 200x harness, and the 2 blue and green wires from the pulser sensor match up, what i'm not so sure about is where to plug the 3 wires (red&black, green, yellow) from the motor to the 2 remaining wires on the 'x' harness? (mauve&black, yellow) Now i'm all confused :crazy: :wondering
Anyone done this before? or got a 200x wiring diagram?
And is there any other advice for this little project?
Anyone done this before? or got a 200x wiring diagram?
And is there any other advice for this little project?