200 auto X

[BigRed_Ryno]

I'm in the process of putting a '84 200s motor into an '85 200x roller. Firstly i only have the mounting brackets for the 200s, which ive found are different to the 'x' frame, this isn't too much of a problem as i can fabricate some bits at work. what's really got me stumped is the wiring, the CDI from the 200s plugs right into the 200x harness, and the 2 blue and green wires from the pulser sensor match up, what i'm not so sure about is where to plug the 3 wires (red&black, green, yellow) from the motor to the 2 remaining wires on the 'x' harness? (mauve&black, yellow) Now i'm all confused :crazy: :wondering
Anyone done this before? or got a 200x wiring diagram?
And is there any other advice for this little project?

[maggiesboy]

if you search 200 auto X there is a sweet article.

the s wires are yel, grn, and red/blk

hook yel to yel
blk/red to blk/red (you will need to splice in a piece of wire for these due to being short)
the green wire then get grounded to the engine case

[maggiesboy]

here ya go.

http://www.files.3wheelerworld.com/MagScans/autox.pdf

[BigRed_Ryno]

Brilliant! just what i needed! thanks for the rapid help :D

[SeaBass8]

Thats a good article to save right there.

Thanks!