PDA

View Full Version : Rear end problem ?



Hayward
08-05-2008, 12:29 AM
I'm not sure if I put everything back properly when I disassembled my '85 BR rear end to clean and paint. No noises, it bangs the rear end when I shift. I've tried adjusting clutch and still shifts hard. Any help would be appreciated !

oscarmayer
08-05-2008, 01:45 PM
dude. sooo many wrong images poped into my head when you titled it "rear end problem". :P

Yamada
08-05-2008, 05:11 PM
First check the tension off the chain.
Check the axle bearing for wear and any loose.
Check the swing arm bearing.

AJZ_200X
08-05-2008, 08:30 PM
Yea i would say first check the two allen bolts for the chain tensioner and then check the carrier assembly to make sure everythings tightened up

atc vending guy
08-05-2008, 08:37 PM
85 big red is shaft drive,right?i recently had a similar problem with my sx and it turned out to be sloppy diff bearings(REAL SLOPPY)i would check that first.then check play in the shaft.

AJZ_200X
08-05-2008, 08:49 PM
my bad...your right it is shaft driven. Chain.?? Guess i wasnt thinkin:rolleyes:

Yamada
08-05-2008, 09:56 PM
ooupps!!! I read a 85 R...

Hayward
08-05-2008, 10:27 PM
85 big red is shaft drive,right?i recently had a similar problem with my sx and it turned out to be sloppy diff bearings(REAL SLOPPY)i would check that first.then check play in the shaft.

Thanks , Vending Guy. It is definitly shaft driven and I did not replace any bearings while I was in there. It feels more like shaft play, I'll check that also. Thanks again for your input.

Erics350x
08-05-2008, 11:24 PM
dude. sooo many wrong images poped into my head when you titled it "rear end problem". :P

LMAO, i like to fell over when read bangs the rear end