Look Here!!!

[sgp56]

Since no ones answering my other thread I decided to make it with a title you cant resist.:twisted: I was riding my 200x when it just died. I checked for spark and got nothing. When i put the engine switch on "off" it'll give me one good spark and stop. When i put it in "on" no spark. Does it sound like the kill switch went out? I recently put a new exciter coil on my 200 so I know its not that. Before it died, it ran great, so i dont know what happened. Help please...:confused: :confused: :confused:

[Erics350x]

unplug the switch and see if it runs. it kills the engine by grounding the ignition system out

[sgp56]

is it the black plug or the big white plug? i unplugged the black one ans still nothing and then unplugged the white one then nothing. Are those the right wires?

[sgp56]

HOw do i unhook my killswitch?

[Eric250R]

Just follow your wires that come from your kill switch all the way down to where they plug in. Unplug the whole thing.

[sgp56]

i did, its a black wire and i unplugged it and nothing. Its weird because i put it on on and nothing the off and 1 good spark then i have to put it on on agian and kick it over for the 1 good spark on off.whats going on?

[cybrman]

I had the same thing happening to me on one of my bikes I resurrected. I could sit there and flip the switch back and forth and as it went off I got one good spark. Turned out I had something grounded that shouldn't have been grounded.
I would look for shorts or a wire that shouldn't be grounded, maybe is rubbing against the frame or something.

[Howdy]

check the advancer on the cam shaft. It is possible the bolt cam eloose or the pin sheared.
Howdy

[sgp56]

alright, ill look for shorts and check my advancer and see what happens.

[sgp56]

I checked and it was some zipties that were too tight on some wires. Gets spark now. Thanks alot.

[sgp56]

Now i tried to start it and it started for a second then died aigan and now no spark again. I dont see where any wires are shorting. What else could it be?

[sgp56]

I figured it out. the cdi connection was loose.