tri-z roller

[yamaha_ripper98]

well i finally got my parts in to do all the bearings and swinger linkages now i just need the 2 roller bearings for the clutch release lever where it goes into the motor and the one on the bottom of the hole i think it holds the back of the imput shaft anyone know where i can find these i was thinking about taking them to a local bearing shop and seeing if the could match the #'s

http://img.photobucket.com/albums/v208/motoboy/PIC-0074.jpg

http://img.photobucket.com/albums/v208/motoboy/PIC-0075.jpg

http://img.photobucket.com/albums/v208/motoboy/PIC-0076.jpg

http://img.photobucket.com/albums/v208/motoboy/PIC-0077.jpg

[evand]

looking good man:beer

[tri-Z ripper]

def coming along well!! keep up the good work every little bit of extra effort will make it even better when its finshed

[yamaha_ripper98]

yea it has deff. came a long way from the $240 pile that i had to begin with, but its a YAMAHA and also a tri-z so it worth its weight in gold to me. but i do have to say i broke down a bit because i now own my first honda the 200x u can see in one of the pics. pulled it out of a barn cleaned the carb and fired right up and idled. needs some bearings here and there tho.

[i58829]

Thats a nice looking roller, one of these days i'm gonna scoop up another tri-z. The first one i had was a basket case and i never rode it but i also paid a bit more than 240.00 for it. Anyway back to the post, looks like a very clean machine. Are you going stock on the motor with a little bit of bolt on stuff? Keep this post loaded with pics as you get stuff done...