Sinbad46
04-02-2008, 03:42 PM
Hi, i've been just changing my bearing and seal from the rear hub on my Z.
First, i push the bearing at the bottom of is place in the hub
But, for the seal, i can close it to the bearing or put it equal at the rear hub end. Which position must be?
If i put flush with the hub, there will be a space between the bearing and seal.
help needed
First, i push the bearing at the bottom of is place in the hub
But, for the seal, i can close it to the bearing or put it equal at the rear hub end. Which position must be?
If i put flush with the hub, there will be a space between the bearing and seal.
help needed