Chain adjustment (and clip of Jumping 125M)

[tand]

Jump clips:
http://s196.photobucket.com/albums/aa230/andrewstrey/?action=view&current=CLIP0013.flv

http://s196.photobucket.com/albums/aa230/andrewstrey/?action=view&current=CLIP0014.flv

(The batteries died at the end of the second clip or there would have been more!! :( )

So today I went riding and we started out jumping a small bank, then about two miles after that my chain started jumping off the back sprocket. Can I fix the problem like this:

zoomerman:

"to tighten the chain there are four bolts holding the axle. you loosen them and them pull the axle back and tighten a little 12mm bolt until it's at the correct tension. then tighten the big 17mm bolts back up"

Or should I just take links out of the chain?

BTW: I have an '85 125M

Thanks

[redryder]

Use the chain tensioner.

[tand]

Use the chain tensioner.

Ya there isnt a chain tensioner on this model, but thanks.
Anyone else??

[redryder]

In your first post you talk about tightening a 12 mm nut. That is your chain tensiorer.

[McDerry]

Theres a chain tensioner, its adjusted by loosening a bolt by the rear brake pedal.

[tand]

In your first post you talk about tightening a 12 mm nut. That is your chain tensiorer.

Ok thanks that answers my question! I havent been able to get a manual yet.