200x clutch help!!

[Brockey]

I put my motor halfway back together today and its going good. Found more gears that were chewed up and replaced them. But now I have the clutch put on and I dont know how much torque to put on the 4 bolts with the springs on the otherside of the plate. I couldnt find it in my manual. Anyone?

[Dirtcrasher]

Those are the tiny clutch spring bolts? 10mm head, 6mm thread? about 5-7 ft lbs. I just use a small 1/4 ratchet and take it easy on them, they snap easy because everyone is paranoid that they will loosen up....

[Mr.Jake]

you gotta make sure they are all the way in (bottom out) then torque them, and go in a criss cross pattern so its even all the way around.

[Brockey]

Perfect guys. After I wear off supper (have a nap) I'll go tighten them down and torque them at 5-7 ft lbs.