brakes

[drhatc200]

waiting to get the money up to get my piston and bore my 85200x while im waiting im gonna try to do a few small things to it.the screws in the lid for the master cvlinders have been broke off and thay are ziptied on any good way to get these out? also is the line going from the rear one down to the brakes is bradied is it suppose to be.ty

[TeamGeek6]

No "good" way to get them out, propane torch on the screw if theres enough sticking out to heat the screw stud and NOT the reservior, otherwise drill the screw out. Could JB Weld a new screw in and fasten the lid with a locknut. Look for brake system rubber parts (master and wheel cylinder rebuild) while its down and rebuild them, they arent too hard to rebuild.

[drhatc200]

ok thanks will ones from a dirt bike work if the line will thread into them?