View Full Version : Progress on my 250R project
Tatersaladx
11-27-2007, 10:14 PM
Finally parts are comin in and i've finally brought the thing to my garage at home. So far, i won a cylinder on ebay, that doesnt look too bad in the pictures the auction says its bored .20 over. Ill wait til i get it and measure it before i order the piston, my air filter, wrist pin bearing, and cometic gaskets came in. I found out the forks are junk so i need to find a set. Will 85/86 forks work? Another thing i found out was that my right rear hub was Yamaha bolt pattern
The crank bearing isnt junk so i dont have to split the cases. Ill have some pics up later.
ceaserthethird
11-29-2007, 07:51 AM
What Trike is this for ?
if this a air fooler R you can use hubs from 200x/250ex/300ex/400ex/450R on there the forks off a newer liquid R wont work unless you use the tripples they are bigger than the air fooler forks
stealthduner
11-29-2007, 01:56 PM
if this a air fooler R you can use hubs from 200x/250ex/300ex/400ex/450R on there the forks off a newer liquid R wont work unless you use the tripples they are bigger than the air fooler forks
He is right, used the entire front end off an 85R (forks/triples/headlight/brakes) on my 83R and basically all ihad to do was make a steering stop. I have pictures if you need to see them
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.