PDA

View Full Version : problems with 83 250r



fast94tracer
10-11-2007, 02:55 PM
well the other day my bike stopped running completely and yesterday i decided to find out what went wrong well i found out that my break light wire got pinched and grounded to the chassis but i thought the coil and lights were on a diff. stator
but i got it started today and i was able to make one trip around the block and it started backfireing and sputtering

anyone know what could be wrong? :wondering

team-red-rider
10-11-2007, 03:39 PM
sounds like carb issues.

Liquid-Darkness
10-11-2007, 03:50 PM
Yeah usually backfireing/popping is a lean symptom. You should rebuild your carb/blow it out and put it back togeather\ and install an inline fuel filter.

Huffa
10-11-2007, 03:54 PM
Could be electrical too ?

fast94tracer
10-11-2007, 04:21 PM
well all of a sudden now its not doing it but i also richened it up one needle clip notch but its starting to breakup in the top end

rally4x4racer
10-12-2007, 12:39 PM
richening your needle clip should not affect your top end.

check you exhaust manifold for leaks? backfire on decel?

fast94tracer
10-13-2007, 11:25 AM
backfired when trying to rev engine but its running good right now all the problems stopped for now

Dirtcrasher
10-13-2007, 11:50 AM
Sounds like crap in the carb, the pinched wire is probably a coincedence...

Are you running an inline gas filter? I'd be sure that where the rear carb rubber boot attaches to the airbox that it has been cleaned and siliconed. This is a common place for dirt to enter prior to the air filter and it makes its way into the carb.

fast94tracer
10-14-2007, 12:25 AM
yes im running a filter and i may not have siliconed it but it makes a great connection