tri z washers on the swinger...

[HEAD09]

hey does anyone have a picture....plz......of the swinger setup are the supose too have a washer or what on each side...i got my seals and bearings from ronnie(thx again) but there seems to be something missing...thx

[honda250sx]

Look in dammits signature and get yourself a manual there is a few detailed looks at how that mess goes together. Thats your best bet.

[LonesomeTriZ]

Do you mean the end caps?

[chris200x]

You got these things under the dust caps?

it goes washer,, bearing,, washer,,, dust cap If I recall correctly

[HEAD09]

well i have that i just didnt see it...until now... i found it finally... i guess im missing the last outside seal...or whatever its called that goes on the very end. outside of the swinger next to the frame... can you use something else instead? dont want to go back to yamaha....thx

[HEAD09]

see my swinger had nothing to start with...everything was gone... but those are cool are those stock?

[chris200x]

There's only one dustcap,, two washers,, and one bearing on each side. that rubber oring in the pic I posted goes on the outside edge of each dustcap.

I'm not sure whats inside the swinger itself. Needle bearings and a spacer on each side I rekon. I got nylon jobbers but havent but them in yet.

[LonesomeTriZ]

Ech side takes one bearing and one nylon bushing. I recomend ditching the bushing and using two bearings

[Bryan Raffa]

:cool: :cool:

[chris200x]

Is there 4 bushings (that look like shock bushings is the best way I can describe them) that go in each end of the swinger before the washers, bearings and dustcaps?

I cannot tell from that parts diagram. I think I maybe missing something as I still have some side to side play in my rear.

[HEAD09]

hey can you measure those thrust bearings and tell me the diamensions of them inside and outside?mcmaster car have them for 3.25 a piece beter then yamaha at 20.00

[chris200x]

Oh man.. that's gonna be a tough one. :eek: Those are old pics I took during the restore. I'd hafta take the whole rear end off.:crazy: I dont think you wanna wait that long. :D

Couldn't you just take the dust cap to them and see if they have something that would fit inside. I'm just not sure about the inside diameter,,

[Yamahondaman]

not sure on the sizes... seems like if you wanna do it right ... 20 bucs ain't bad