still got a spark prob....

[capebretonmoose]

looking for some voltage information for a honda 200e, having a hell of a time to get the bike running again. will love any help i can get.

[stoney420]

do u have a manual? if not then heres the link where u can download a manual to the 200e bigred which is what u have..im pretty sure there is a wiring diagram and etc in it, you should be able to figure it out with this.. hope it helps, heres the link just click download at the bottom..
http://www.drivehq.com/file/ShowFile.aspx?catID=0&subCatID=0&view=&sort=&isInc=&isGallery=true&share=true&shareID=233462&parentID=636956&fileID=4211358&curPage=0&ft=8/26/2006%204:33:58%20PM
~Stoney~

[Dirtcrasher]

There are SO many posts on here like this.... Electrical problems have no simple answer but can be a simple problem. You MUST get a manual and start testing the parts with an OHMM meter. Most electrical problems are very easy such that a loose wire or bad connection or switch are usually found.

Get a book and start testing, if your not good with electrical then bribe a friend with beer - always worked for me....

[bobbyD]

could not start my 200E unless i had a new plug (ngk DR8ES-L) then it would foul in under 2 minutes, cleaned carb,verified needle position (3rd),air pilot screw 1 7/8 out and still fouling plugs faster than i put them in..then i replaced plug with champion recomended ( RA6HC ) and never had a problem since,perfect idle and starts every time.. to be honest i dont understand but it works

I spent days reading these forums and got all the info i needed to get my bike running like a champ

Thanks to all