250R rod bearings???

[torker]

Hi there guys...
I've search the forums but I didn't find the answer to my question.

Is it possible to change the rod bearings on my 86R?:confused:
Are those available?
I'm not looking to replace the hole thing, just the bearings, if possible.:wondering
Any help is apreciated.

Thanks in advance,
TORKER.

[BigRedRunner]

Yup, the side bearings on their own are readily available item from Honda.

[torker]

BigRedRunner, are you refering to the cranckshaft bearings or the rod bearings?
TORKER.

[BigRedRunner]

It's the plural that threw me. I saw bearings and immediately thought of the case bearings for the crank. The small end bearing of the rod is no biggie. Normally, you would buy a connecting rod kit that would get you a big end bearing, crank pin, and a rod.

As a side note, I could not locate the right countershaft bearing for my 200x or balance shaft bearing for my 250R. I simply got the numbers that were stamped right on the bearings and located what I needed in town.

[Mosh]

I am almost positive that Wiesco can get you just the big end bearing and thrust washers.
Really for a few bucks more though,You might want to consider a whole new rod kit.

[jeffatc250r]

I think you can through honda, atleast you can for a cr500, had to get it all piece by piece because nobody made an aftermarket for the 85, it was expensive. Like moshman said, better off buying the whole kit.

[torker]

Thanks guys, I'll see what I can find and is more convenient.
This is the beater, but it needs/deserves to be done right!!!

TORKER.