What's wrong w/ this pic?

[JAYSATC]

The front wheel rubs when i turn hard?

[oldskool83]

fork may be bent...unless your frame is, i say forks, the wheels to close to the motor.

[BigGreenMachine]

That a 70? Your frame is bent putting the tire too close to the motor.

[team-red-rider]

what kinda 3wheeler ATC70?

[JAYSATC]

yep. ATC70

[team-red-rider]

check underneath you fuel tank for a bent frame...teh 70's had a tendency to bend under the tank which causes the tire /fender to rub the motor

[JAYSATC]

If the frame is bent, will that be an expensive fix?

[bassman]

Do you know how to weld?
You'd be better off buying a new frame for it.

[thefox]

If the frame is bent, will that be an expensive fix?

No. The easiest way to fix it would be to just pull the tank and have the bent piece cut out and a new pice of pipe welded in. I would slide a smaller pipe inside the bent section and weld that in there too for extra strength. You can also get a good used frame and swap everything over. I did the frame swap on the last 70 I had because I found a used frame for $20 close enough for me to pick up.

[JAYSATC]

Do you think $260 is a fair price. It runs ok

[Dirtcrasher]

Less than 500$ for anything that runs is ok.

Are you sure that the front tire is the correct size??

[team-red-rider]

take off the fuel tank and tank a pic of the frmae under there and post it

[Eric250R]

Less than 500$ for anything that runs is ok.

Are you sure that the front tire is the correct size??

Was thinking the same thing, is that the stock size tire ?

[mymint87]

Was thinking the same thing, is that the stock size tire ?

I was thinking stock 70 size....just about 300 lbs of air pressure in it:welcome: ...........LMAO

[chris200x]

I woulda stripped it down and changed frames without even thinkin about the air pressure! :lol: :rolleyes: YES by all means,,, try letting some air outta the tire FIRST! :D but I guess it wouldn't hurt to look over the frame real good for cracks.

[JAYSATC]

THE TIRE IS 16x8x7

[rally4x4racer]

have you ran into anything on it?

[JAYSATC]

I Just Bought It. The Guy I Bought It From Didn't Know Much About It

[JAYSATC]

Looks bent to me...

[team-red-rider]

yep thats your problem u can fix it 3 ways. new frame . heat it and bend . or cut that piece off and weld a new one on

[edog]

Shave some rubber off the tires:p .That should help!!!!!!!!!!


Maybe the forks are bent inward.

[Dirtcrasher]

Don't all the ATC70's have a slight arch to the frame tube??

[RedRider_AK]

Yeah that's definetely bent. My two 70 frames don't look anything like that up at the neck. I'd take thefox's advice and cut a section out and weld a smaller tube in it's place.

[rally4x4racer]

the guy you got it from SAID he doesn't know much about it :)