Atc400ex 86-02

[Eul-Buck]

Hello, I'm new on this forum, and my english not very well, I live in St-Juste du Lac, at approximately 35 miles of borders of New-Brunswick and Maine US

My friend and me build a custom ATC400EX, it's a 350X 86, with an 02 400EX engine, it is stock for the moment, and have to project to oversize cylinder at 416, or 426 cc, with titanium bearings, or other heavy duty bearings ;)


I polished the intake hole, now, i'm not sure that the best idea....but, it's to later...

On this picture, the front fender is not installed...



http://img164.imageshack.us/img164/1383/atc400exxk8.th.jpg (http://img164.imageshack.us/my.php?image=atc400exxk8.jpg)

It's me on the picture ;)


Shoot me your suggestions, for the modifications :beer

Scuse me for my english :rolleyes:


Dany

[riverrat]

Welcome to the forum.

That is a nice project.

Does the 400ex motor have water cooling?

[BigGreenMachine]

Very cool project. I bet it'll be a real ripper with a bigbore.

[Mike_Ham_250R]

Welcome to the forum.

That is a nice project.

Does the 400ex motor have water cooling?

No sir 400ex is air cooled.

[SYKO]

nice!! I love the back ground in the first pic very scenic!! that should be a bad trike when your done!

[RedRider_AK]

And by "bad", Sykolincon means "good" or "great" or "extremely great"

[Yamada]

Salut québécois!!!
It is a nice bike that you have.
Was it hard to fit the 400ex engine into the frame?

[NOS_350X]

I was thinking about doing the same. I have a 426ex thats setup for flattrack, and i want to put my cr500 in it. Then i will probably take the 426 put the stroker crank i got for it in there and put it in one of the 350x's i have.