GoodKarma
06-19-2007, 09:04 PM
I need to make an intake for my Z project, and I'm looking to see if the experts can offer some advice. Who makes intakes that are aluminum to mount the rubber boot to the carb? I have a Mossbarger on my air-fooler that looks like I could modify to work, but they are hard to get any replies from via email. Any suggestions?
I have a plate made to mount to the YZ intake bell, and I have a rubber flange to mount the carb to, but I need to get a downward bend of about 20-30 degrees to put between the mount and flange. Does anyone make these intakes like the Mossbarger aluminum setup that I have for my air-fooler?
I have a plate made to mount to the YZ intake bell, and I have a rubber flange to mount the carb to, but I need to get a downward bend of about 20-30 degrees to put between the mount and flange. Does anyone make these intakes like the Mossbarger aluminum setup that I have for my air-fooler?