McDerry
06-18-2007, 03:34 AM
Okay was at the local dump today and noticed a 3 wheeler frame in the scrap metal bin and pulled it out. Well it just happened to be a descent portion of a klt160A, forks, frame, rear axle and carrier, driveshaft, engine, coils, and black box mounted on the frame that the wires from down by the crank run too (would imagine this is the cdi). A couple of the fins are broken on the jug but from a quick inspection the motor seems intact for all the major pieces except recoil, and the carb and loads up with compression when you turn it over. SO before I deam this as a lost cause and part it out, Im kinda fancied by the shaft drive with reverse.
So the main question is does anyone know how the wiring for the ignition works on this so I can test it for some spark??
What size carburetor was on this bike originally?
Do any other hubs fit this??
So the main question is does anyone know how the wiring for the ignition works on this so I can test it for some spark??
What size carburetor was on this bike originally?
Do any other hubs fit this??