tri z help

[HEAD09]

hey guys need help.. the diagram that i have doesnt show which springs go in first ...there are 3 on the front forks but im not sure how they go it been a while since i took it apart thx...

[super90]

it usually goes largest, medium, small. Thats atleast how my 200x forks work

[HEAD09]

thats what i thought but i haveing problems get the bottom seal in so it makes me think im doing something wrong..

[HEAD09]

it goes metal seal first the seal then washer then lock ring then last is the top seal right??? i cant seam to get the lock ring in do i have the right order???and is 2 ozs of oil in each right???thznks for the help???

[Bryan Raffa]

this should help ya ... the top seal has to be driven in cast the clip groove

[HEAD09]

okay ive tried both ways and still nothing...i cant get the seal below the ring grove... and already think the seal is going to be shot...help i did what the picture shows but that firts metal ring is stoping it from getting low enough///i about ready to leave out the metal washer so it works....help

[Bryan Raffa]

are you useing a seal driver... its nessary to have one to drive it in...you can make one if you find a pice of pipe that will slide over the fork tube and fits in the tube

[HEAD09]

i did but i was worried about strewing up the seal buy hitting the top of it...i just was trying to make sure that i didnt do anything wrong...by the way does it make it any better or worst to put the spring different by switching them??? ive read that some people put a piece of pvc(ithink) TO REPLACE the little spring...thanks again