putting it back together, finally!! (pics) *updated more pics!!

[jagerlager]

YTM 200k re-assembly... quite a learning experience.
fixed exhaust, clutches, sprocket, chain blast and paint everything, clean, strip paint off plastics and re-do, re-cover seat, new clutch and stator cover screws... etc...

[84honda200s]

lookin good man

[edog]

:w00t: :w00t: :w00t: :w00t: :w00t: :w00t:

Pm Sent..........

[BigReds Forever]

very nice!

[jagerlager]

A few more pics... a little dusty, but Im excited.

[jagerlager]

and a few more

[jagerlager]

a before picture

[84honda200s]

danm man. its getting there and looks 200x better than it did.

[edog]

It really didn't look all that bad to begin with.

[tyman]

200k?? never heard of a 200k... then again i'm not all that familiar with yamahas..

[team-red-rider]

no...200k = 1983 yamaha YTM 200

[jagerlager]

we took 'em out the other day... Ran great, smooth clutches, finally idles perfectly.
A load of thanks to you guys!! going to build a front rack next.
a few more pictures...

[jagerlager]

a few more

[thefox]

Very nice Jagerlager! It is nice to see a hardtail cleaned up like that. Did you have to buy many parts for it? How did you clean the bare aluminum case halves?

[jagerlager]

thanks man! I only needed a chain , sprocket, grips, and some thick vinyl for the seat. everything else has just been clean and re-newed. bought this thing for fifty bucks two years ago. just needed some tlc. the case halves were gone after with a small dremmel wire wheel and scotch brite pads. everything else I blasted and painted. I scraped all the bad off the plastics by back blading with a razor blade, and wet sanding... layers of paint on this and massive oxidation. cleaning the carb very thoroughly, working a bit on the clutches, and a new chain and sprocket(front) did the trick... the motor doesnt smoke at all and has good snort.

[gizmo_22]

great job man, hopin my 185s looks 1/2 as good as this and ill be happy.. mind u covered in mud no one will tell. :P