oil change

[82atc200]

i have a 82 atc 200m (the basic verison) anyway i was wondering how u change the oil in it i looked around on the forums and i couldnt find anything any help will be appreciated

[DeePa]

look for the service manual post and download the manual.

mike

[Yamada]

1: start the engine and take a ride to warm it up
2. Shut off the engine
3. Remove the oil drain plug ( i dont know where it is on this model)
4. Remove the oil filter ( I think that this model got one) and replace it.
5. Rebolt the oil drain plug
6. Pour some 10w30 or 20w50 oil recommended for wet clutch.
7. Check the level onn the dipstick.
Maybe someone else can give you some info for the drain plug. the oil fiter and the amount of oil needed.

[Russell 350X]

Let it warm up, then let it sit for a minute. On the left side of the motor there is a drain plug (24mm i think?) and there will be a little screen that comes out with it, looks like a thimble thing. There is a spring also. Make sure it all goes together the same. Drain. Put screen and spring in, then the plug. Then put whatever oil the manual calls for. I use10w40.

[team-red-rider]

ok the standard 200 oil drain is below the shifter (there is no oil filter)

[trikes4life]

I drain the oil out, and fill it up with karosean(1.25 quarts) run it for 10 seconds, drain and replace with only WET CLUTCH OIL.