200S carb settings???

[MIK6]

My 84 200s is being a pain in the trailprotrailprotrailprotrailprotrailpro. Does anyone have the settings for the carb? I pulled the carb off and put a new O-ring between the intake and the carb. It ran great til I put gas into it and put the airbox cover back on THEN NOTHING. It has spark, compression, and it is getting gas, but it will not run.

ANY HELP APPRECIATED
MIK6 / Mike

[moe]

hay mik6 go to www.3wheeler.org/tech. click on 185 carb adjestment its the same as a 200s. only two adjestments. :)

[wanta250r]

For 1984 models the model number is PD 85C
85-on Pd85D
The Main Jet number is 100

The initial pilot screw opening is 2 1/4 turns out
The needle jet clip positon is the third groove
The Float level is 0.49 in. (12.5mm)
The idle speed should be 1400 + or - 100 rpm

[LaDano]

Just got mine back to running right I had to put all the old crap back in, come to find out the neddle valve was to short causing it to run way to rich. But as the book says the settings above are right on. Check to see if you have a vaccum leak around the new o-ring, could be the culpret since nothing was changed.