Tri-Z axle suggestions......

[ATC-Eric]

Im in the market for a good rear axle. My stock is to narrow for my taste, aside from having gummed up splines.

So does anyone have any good suggestions for an aftermarket that would give me a wider stance? I know I have to go with a Banshee setup to fit my bearing carrier, and am assuming I must go with the Banshee hubs as well to fit my rims.

Durablue? Lonestar?

Any advice is appreciated.

Thanks

[Kintore]

Watch ebay for a + shee axle, or buy a new one. When I was in the market +4's were going for about 200ish. Ive heard nothing buy good things about lonestar, but durablue ive heard a few complaints. Some call them dura break lol

[ATC-Eric]

Thanks Kintore!

I am done with used axles, just gettting someone elses issues. I am going brand new on this Z.

The Banshee hubs fit the Z rims correct?

Thanks again.

[Kintore]

Negitive, if you run shee hubs you need shee rims. I had shee hubs and ITP rims and my Z hubs would not fit them. You need a all Z setup on the hubs/rims or a all shee. Only thing in common is both splines are the same.

I got Z hubs if you need them.