David Bartlett
01-16-2007, 12:29 AM
Hi guys,
Found this nifty little exhaust pipe desing tool online. Plug in a few varables and it spits out the design.
http://www.mh-aerotools.de/airfoils/javapipe_main_en.htm
So lets pool our knowlege and make a pipe.
What we need to know:
RPM, Exhaust Port angle, Transfer Port Angle, Exhaust Port Area, Exhaust Gas Temp.
If you know any of these variables, post it here. Once I get all the info, Ill weld up a pipe and test it.
RPM would be 5500
Fuel type is gasoline.
Exhaust Port is 35mm (diameter) so I'm guessing the exhaust port area is 964 (not sure on this)
Found this nifty little exhaust pipe desing tool online. Plug in a few varables and it spits out the design.
http://www.mh-aerotools.de/airfoils/javapipe_main_en.htm
So lets pool our knowlege and make a pipe.
What we need to know:
RPM, Exhaust Port angle, Transfer Port Angle, Exhaust Port Area, Exhaust Gas Temp.
If you know any of these variables, post it here. Once I get all the info, Ill weld up a pipe and test it.
RPM would be 5500
Fuel type is gasoline.
Exhaust Port is 35mm (diameter) so I'm guessing the exhaust port area is 964 (not sure on this)