Here are some pics of my '86 350X-finally back together!!!

[roofinggun]

Can someone tell me how to hook up my tether swith. It is a handlebar mount Emgo that I got from a friend. It has the plugs at the end of the wires to jump, one is black and one is white. Thanks

[plkmonster2]

kinda rig it into the kill switch, btw, nice 350X

[J.D.]

Nice trike there, roofinggun!! BTW....what is a tether switch? :oops:

[roofinggun]

It is a kill switch that has a rubber stop which engages a button on the switch. The rubber stop attaches to a lanyard which you hook to your wrist or sleeve. If you fall off the lanyard will pull of the rubber stop and kill the engine. It is required for a lot of race circuits, but I just got it because the 350X has no key and it will help keep the honest people honest and the stupid ones baffled.

[YTZ250#1]

Hook the black wire to a good ground on frame,then hook the white wire
to the neg. side of coil.that should ground out the coil and kill the motor
when cord is pulled.

[hrc200x]

Nice 350x. What all did you have to do to it?

[roofinggun]

Well, I had to change the front & back bearings & seals, rear pads, front tire, drill and tap the foot peg hole and reinstall, and change the sprocket hub. Then I straightened out the skid plates and did some touch up painting and the basic motor tune up. It starts great and runs nice, but I still need to adjust the valves and probably change the swingarm bearings next winter. I figured I'd better ride somemore before I put too much $ into it. I'm at about $1350 the way it sits. But that doesn't count the blood, sweat, and cussing :D