would this work?

[Dave223]

I have an 84r, and from searching around, I found that swinger parts are non existant or very pricey!!! I was looking at my daughters 300ex and it got me to thinkin...would it hurt the carrier if I was to take it, invert it, and weld it onto the rear of my swinger? with a RAD carrier inside it, I dont see how it would hurt it to run with the sprocket on the right side like the 84. If I used say, a rear carrier from a 400ex or 450r, I could then have the option of wider axles, better brakes, different brake rotors,better bearing carriers and so on....what do you think? Would it hurt to run it upside down?

[3leggeddog]

no but you may have alignment issues.are the 2 carriers the same in length,and diameter?

[Dave223]

I dont think the length or diameter would matter. As long as I line up the sprockets, then tack it off to the swinger, it should be ok...as far as the alignment is concerned, that shouldnt be a problem either, just have to measure twice, tack weld it once! I would use everything from the 400, the brake setup and mounts,so that would make it easier. Im thinking the only problem might be if it moved over too far to one side to line up the sprocket, it would put the tires off center. I didnt think about that part. Dave

[Troll 2]

I have an 84r, and from searching around, I found that swinger parts are non existant or very pricey!!!

What parts do you need?

[dizasterzrfun69]

What parts do you need?

I'll take it all for $100 :lol: :lol: very nice!


Kevin

[Troll 2]

Sorry, but I'm using it...lol. I was just wondering which particular componets you need to revive your swinger?

[BLAZERONE22]

I have a RAD double row in my aircooler... Xststem makes new poly bushings for the pivots which eliminates the collars and needle bearings...

http://www.radmfg.com/carriers_double.htm

http://i25.photobucket.com/albums/c67/blazerone22/Rparts048.jpg

[Dave223]

hey troll,
I will trade you my wife and 2 kids...all have good backs and good eyesight! Nahhh JK...ok no Im not....why did you have to show me that????? YOU TOO BLAZER!!!!

I didnt know about the RAD carriers, thanks for the link....and does XSystem have the kits ready for the 84s yet? If so I didnt see the thread...man oh man, I need that kit.

Troll, whats the measurement from hub face to hub face on your axle? I measured mine today and came up with 33 1/2" Dave

[Troll 2]

.Dura-Blue Axle;
It's about 38" wide and dia. is 1.180 at the smallest and 1.380 ( axle dia. not collar)

It didnt look like that when I got it....lol
http://www.bmi.net/magoos/p2.jpg

Dads got me some bearings http://www.3wheelerworldforums.com/member.php?*Edited*=691

Good luck on yours..........................:beer

p.s. thanks for the offer, but I have a wife and two kids of my own....lol

http://www.bmi.net/magoos/FAMILY.jpg