Clutches (quick idea)

[86200s]

my 200s clutches are a 4 pack and I have an extra set of clutch discs...I was wondering if I could make it a 5 pack? the clutches were slipping so Im replacing them. and there are more mods to come so I want to be sure I get as much to the tires as possiable. The engine is apart as we speak and I wanted some input before I put it together and either "Fly or Die"

Thanks for you time

[atctim]

If it comes with 4 discs and you replace it with 5 - you will have clearance issues, or you won't be able to put it back together - (too much spring tension). Go with the factory specs on # or discs and you'll be fine. You are not gonna increase the power enough to slip new discs.

[86200s]

Alright, 4 it is...it was a idea, I didn't day it was a good one :D

Thanks

[atctim]

86200s;

Out of curiosity, how much do you weight?

[86200s]

bout 140lbs

[86200s]

lol...maybe if I was 200+ it would be a good idea

[atctim]

OK - if you are upping the horsepower to say 16HP and you weighed something like 350 lbs - then you may be concerned about the clutch, but rest assured, you'll be fine.

[86200s]

Im prob at around 16, 17 hp right now...but I think your right, Im gonna put it back together now

[86200s]

I did 5 pack, couldn't help it...but it pulls hard 0 slip and no problems I guess its a good idea so far...when I put the other Ported head, cam, and xr200 carb I think it couldn't hurt to have the 5 pack setup...to ensure 0 slip

[slothminx]

Im prob at around 16, 17 hp right now...but I think your right, Im gonna put it back together now

Lmao:lol: :lol: :lol: What mods did you say again?

[86200s]

hahaha...nothing I am or if not will be VERY soon, .20 over, 10:25:1 piston, xr200 cam, 200x carb, straight pipe, Port and Polish and soon to come and extreme p&p head with Quelches to raise compression to bout 12:1 and a powroll cam and xr200 carb