110 valve clearance/carb setting

[mags83]

Quick question: what's the valve clearance supposed to be for a 79 110 on the intake and exhaust? Also, how far out is the idle mixture screw supposed to be? Thanks much.

[dufrain]

I dont know on the valves and I asked the same q on the screw.Supposed to start at about 2 turns with a warm engine and turn in ,while counting turns,until its begins to run rough then back out until it runs rough,then put the screw in the middle of those 2 points.I ended up with 1/2 turn out from seated to get the best throttle response.make sure your air filter is clean before you start.

[Tri-ZNate]

valve clearance is supposed to be
0.07mm (0.005in) for both valves