PDA

View Full Version : Engine Fitment.


SpeedBump
01-24-2006, 07:43 PM
Ok, I got a ATC70 that is in need of a pull starter and some electrical pieces. I just picked up a Z50 Motorcycle with a good running engine. Can I swap out the topends on these two engines. I am 95% sure the bottom ends are the same, (Save for the kick start) so I think it should work. If the topends don't interchange, at least can I use the electronics from the Z to get the ATC running? Thanks.
MTS
01-24-2006, 08:58 PM
Ok, I got a ATC70 that is in need of a pull starter and some electrical pieces. I just picked up a Z50 Motorcycle with a good running engine. Can I swap out the topends on these two engines. I am 95% sure the bottom ends are the same, (Save for the kick start) so I think it should work. If the topends don't interchange, at least can I use the electronics from the Z to get the ATC running? Thanks.
Im pretty sure they are, Cause i know guys put the 70cc top ends off CT70's (same motor) on there XR50's for a cheap big bore..