225DX Swingarm Bearings....

[350x'inNY]

Hey... the only real issue with that 225DX Swiney found me in MI is the Swinger bearings.... (axle seems tight) Question is, can you replace the swinger bearings in a 225DX without taking the whole rearend/axle apart? The Yammie manual tells you to disassemble the rear axle/gearbox, etc.

might have to put in that Durablue Extended axle if I HAVE to mess with the rearend/axle bearings! :beer

Bruce

[Louis Mielke]

You mean the pivot bearings up in the frame? No you don't its just a pain to make sure you don't drop the drive shaft. I always wanted to check into putting the rear end from a bear tracker onto a YTm. I beleive its wider, and the engine is the same.

[edog]

You will have to remove all those components to replace bearings.I have done this.2 hours worth of work at the most.

Post pics if you put that axle in?:cool: