84/85 Tecate Mudflap question

[Orangecnty250r]

Does anyone have OEM mudflaps on their 84/85 Tecate. I found an NOS set of Mudflaps for my Future Red T3 project....My stock red fenders (I know they are OEM) have no holes for them.....I went to the Kawi website Fiche and it looks like holes should be there....Looks like the same for 84 and 85 anyone have good info or pictures on this.

[90nut]

Mine used to have those mud flaps on it and in my factory fenders there were holes. Belive they were held on with screws also. I can double check tomorrow morning though.

[going4broketecate85]

Almost sure that they are suppose to have holes in them from the factory. Can you post some pics of your fenders??

[atckowalski]

I have both the oem fender with the holes and the mud flapps and will take a pic later today.

[Orangecnty250r]

I have both the oem fender with the holes and the mud flapps and will take a pic later today.

Thank You ...I would like to see a picture of what the fenders are "supposed"to look like

I looked closer....Seems someone shaved the part with the bolts holes off to make them look "racier"

To bad:( They are decent red fenders that are not easy to come by....I was was planning on wet sanding them until I dropped...I will still clean them up but the HUNT for really red fenders with the mup flap "connection" is ON!!!

[BLAZERONE22]

I've ran across them without holes before, heres a old one I used to have...

http://images.snapfish.com/34592%3C342%7Ffp46%3Dot%3E2324%3D589%3D656%3DXROQD F%3E23235476%3B%3A994ot1lsi

[250rulzes]

Here is the stock configuration.

[atckowalski]

I have not yet had a chance to post a pic but I can tell by looking at your picture that your fenders have been cut/shaved. There should be an edge on the bottom that sticks straight out that the fenders mount to.I will try tommorow.What do you have for a carb? I am going to buy a new one but I am not sure which one to buy? Any ideas?

[BigGreenMachine]

Contact Sudco and get a "special set" 38mm flatslide. They will jet it for you and the larger carb really makes the T3 snotty.

[tecatecrazy]

yep, that fender there has been race cut. i have a set of uncut red rears in the rafters of mt garage (and thats where they will stay :p ) that still have the mounting plastic attached. picked 'em up off ebay for $85 never mounted :naughty:


joe

[going4broketecate85]

yep, that fender there has been race cut. i have a set of uncut red rears in the rafters of mt garage (and thats where they will stay :p ) that still have the mounting plastic attached. picked 'em up off ebay for $85 never mounted :naughty:


joe

Hey Joe, could you post a pic. of those new Red Tecate fenders so we can drowl all over them?

[tecatecrazy]

they were actually mounted on my trike for a month or two (probably about three hours of ride time) and have been on display on the boards before but here is a couple of refresser pics.

[atckowalski]

Well here are the pics I promised,,,