PDA

View Full Version : Quick 250es question?


boogie5184
12-06-2005, 10:36 PM
Is the rear end houseing and the axle tubes on a honda 250sx the exact same as on the 250es. I am looking for the left side (short) axle tube and I have seen them on ebay for the 250sx and I would like to know if they will work on my '85 250es.
ScottZJ
12-07-2005, 12:03 AM
Yes its the same.
Dads
12-07-2005, 12:36 AM
I have one 5.00 + shippng.
boogie5184
12-07-2005, 03:26 AM
That sounds like a good deal dads, Is the bearings in useable condition or will they have to be replaced? Also do you have any more 250es parts?
Dads
12-07-2005, 09:41 AM
It has no bearings in it. I have SX parts so only the ones that interchange. I have bearing kits for it. rear axle kit 85 250es $56.50 86/87 250es $45.67 . + shipping.
ClayW
12-07-2005, 02:11 PM
I was under the impression they were different. The axles are definately [/*]different lengths. I have one or two of those axle tubes for a 85 ES at the house if im not mistaken. Swingarm too.


ClayW
jeswinehart
12-07-2005, 07:26 PM
Yeah I seen this post this morning and I am thinking there is a difference also. No matter what my manuals say or the pics look like.
I am positive the sx uses a shorter tube on the left side.

john
boogie5184
12-07-2005, 08:34 PM
O.k. Thats good to know! So CLay, Let me know if you have One at the house. I would prefer on ewith usable bearings in it if you have one. Just let me kno wwhat you have and how much? I messed up the threads on my axle but won one off ebay so I should have it in a week or so. Also there is a '86 Big Red in Americus, Ga on ebay I am probly going to bid on as long as it stays real low. Not much parts but if its cheap I will drive an hour or so to get what parts I can.
ClayW
12-08-2005, 11:59 AM
I will check this evening on the axle tube. I almost certain I have 2. Bearings may be an issue though. Dont remember.

Clay
boogie5184
12-09-2005, 02:30 PM
just let me kmow what you find. thanks!
ClayW
12-14-2005, 08:17 PM
Yeah I have a good one. The seal is good, but the bearing is gone. If you want it let me know.

Clay
boogie5184
12-14-2005, 10:25 PM
Let me get my axle in, I may still be able to use the one I have, I think that I may have pushed the bearings into the tube to far. When the axle gets in I will be able to see if I have it right now. But I will let you know.