View Full Version : 300r intake boot
eighty8mmsnail
11-18-2005, 05:58 PM
I have a 300r kit that I am putting together and I was planning on using a 38mm flat slide card. I have stock 84r that the kit will eventually go on and I was wondering what to use for an intake boot. Will boiling the stock boot and stretching it work fine? Also what would you suggest for reeds?
3leggeddog
11-18-2005, 06:05 PM
check with boyseen to see if they make a rad valve for that bike.the rad valve will usally accept a 38mm carb no problem
BigGreenMachine
11-18-2005, 07:17 PM
should be able to boil and stretch the stock boot.
hrc85250r
11-18-2005, 07:59 PM
the reed cage bolt pattern on the a/c and l/c 250r's arent the same??? i thought they were....
BigGreenMachine
11-18-2005, 08:40 PM
They are, the liquid R reed cage and boot will fit.
ATCWRENCH
11-21-2005, 11:04 AM
go to www.1dirracing.com they have an intake that take a 38mm carb and its a straight shot into the reed cage. you can even upgrade the whole intake system from the them, intake cage and reeds. I plan on using them when I get my a/c R back together and my 85 T3
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.