PDA

View Full Version : Need Tri-moto 175 Cylinder Specs !!


MTS
10-09-2005, 07:06 PM
Im looking for the stock bore size for a 81 tri-moto 175 along with Maximum/minimum cylinder wear size
Thanks.
Six Stroke
10-09-2005, 11:01 PM
Stock bore is 66mm, I believe. I'll post the limits tomorrow if no one else has put them up by then.
Six Stroke
10-10-2005, 05:34 PM
Bore - 66mm
Taper limit - .05mm
Out of round limit - .01mm
Cyl. to piston clearance - .040 to .045mm
Bore wear limit - 66.1 mm
Ring gap - .30 to .50mm
MTS
10-10-2005, 05:38 PM
Thanks a ton...will make it much easier!