Mr. Kind
10-06-2005, 06:57 PM
anybody familiar with the LA Sleeve 295cc Big Bore Sleeve Kit? and if so will the stock lower end (crank & rod) handle this? i'm asuming i dont need a spacer plate for this setup?
and does anybody have an idea if theirs an entire lower end bearing kit? i've asked before & got some good info from ordo on using 8 ball type used in 98-01 cr 500 instead of the 7 ball type used stock. Service Honda part # 91003-KA4-771
the lower ends in the shop (i did'nt have the tools to split it) & i've got a complete gasket set already, should i get the complete oil seal kit too? how many bearing are in the lower end?
i'll snap some pics of the R with the motor off of it tomorrow
and does anybody have an idea if theirs an entire lower end bearing kit? i've asked before & got some good info from ordo on using 8 ball type used in 98-01 cr 500 instead of the 7 ball type used stock. Service Honda part # 91003-KA4-771
the lower ends in the shop (i did'nt have the tools to split it) & i've got a complete gasket set already, should i get the complete oil seal kit too? how many bearing are in the lower end?
i'll snap some pics of the R with the motor off of it tomorrow