tri moto will not start

[42F67N]

this tri moto i just got wont fire over not at all ive cleaned the carb has 120psi of compression tons of spark but when i ty to start it nothing dosent even pop once to try to start????

whats the compression on these trikes no one seems to know for sure and the homepage dosent have it listed either?

whats the carb settings?

[slothminx]

first thing to try now is whip the plug out put a few drops of petrol in the hole plug back in and then try
............

will

[42F67N]

ive pulled the plug and its allways got fuel on it

[slothminx]

could be flooded then. take the plug out and take it iff the lead set the kill switch to off and turn the engine over for about 20 secs

dry that plug off pop it back in and see if she fires, i would think that 120psi would make it fire up fine

Will

[slothminx]

give it full throttle when you try to start it aswell ;) if nothing try half throttle.

[42F67N]

Carb needs a rebuild i guess?

anyone know if the fork boots for a tri z will fit the fork boots on the tri moto 125 forks? also these forks are just spring forks right there no fluid or seals in them?

[brapp]

i'll look in my one book, and get you all the info you could ever want, i am sure it has the 125 and 175 tri moto's in it,

[42F67N]

thanks brapp i also need to know the float level specs

[brapp]

ok what size is it, the yt125g yt125h, are one jet needle is4e16 with a main jet#110 with jet needle 0-6
pilot jet #20 throtle slide cutaway of 1.5

the yt125j yt125k yt125lyt125n are all, jet needle 4e16
yhe main jet is a #200 the needle jet is a 0-0 the pilot is a #25 and the throtle cutaway is 1.5,

and the all the 125's specs are this, idle speed 1550rpm, champion plug number-n10y,

electrode gap 0.7-0.8mm (0.028-0.031 in) the cdi should advance 15 degrees at 2000rpm, the carb is a mikuni vm20ss with a 20mm bore (0.787 in) float heigth is 21mm (0.827 in) clip position is 3rd from top,

and if it is the yt175j the specs are-jet needle is 4k4 main jet is#165, needle jet is n-8 and a pilot jet #40 with a 2.5 throttle cutaway, the idle is also 1550 rpm plug number n10y,electrode gap of 0.7-0.8mm (0.028-0.031 in) cdi advance 15dgrees at 2000 rpm float heigth is 25mm(0.984in)

hope this helps out, if you have any other questions call em and mabey i coudl answer them. but this is all i knwo od for the time being.

[42F67N]

Thanks brapp