gokartjon
10-03-2005, 06:58 AM
I have a few general questions about the stator coil on a 1984 200es. I purchase a new one from hyper parts and I am getting ready to install it. The design is slightly different and I do not have that much atv repair experience.
Does the wire get soldered to the tab sticking out of the middle of the windings on the new coil?
Is there some type of gap clearance measurement for the new coil?
Thanks for any input,
Jon
Does the wire get soldered to the tab sticking out of the middle of the windings on the new coil?
Is there some type of gap clearance measurement for the new coil?
Thanks for any input,
Jon