tri zinger ?

[Preddy05]

does anyone know of another carb that will fit on a tri zinger?
mine is missing the choke assembly in the carb and when i do get it started it will run for a little and then die on me. If i let is sit for a little again it will start back up and do the same thing...is it because of the carb or could this be caused by something else? please help

Mike

[42F67N]

The carb off a yamaha pw50 2 stroke dirtbike will work on it

[Preddy05]

The carb off a yamaha pw50 2 stroke dirtbike will work on it

Are you sure? I just wanna make sure before i go out and buy one and if i put a pw50 carb on it will it effect the way it runs? And will any other parts from the pw50 fit the zinger?

[Tri-ZNate]

If it was me I'd clean the carb before I go buying a new carb, but that is just me.

[Jason Hall]

Make sure the on/off/start switch is not bad. I have a 4 zinger & the switch went bad and it would shut off when ever it wanted. I started unhooking one wire at a time in the harness under the tank, & when I unhooked the red wire it stayed running. Mine will now start in the on position & the start position, but will still shut off when turned to off. It could also be the coil or cdi box. A pw-50 carb will probly be a little smaller bore & will most likely make it run a little slower (I don't know for a fact that the carb is smaller), but I know it will bolt right on. I would get the choke parts & put the origional carb back together right before buying a new carb. As far as other parts fitting, alot of the engine parts will fit.

[Preddy05]

When i first got the bike i thought the carb needed cleaned so i took it off and cleaned it. and it started but still shuts off after its run for a min or 2.

[42F67N]

I know someone that put a pw50 carb on a lil zinger 60 no diffrence at all you can look on bike bandit and see the carb for a pw and a zinger are the same

[Preddy05]

ok looks like i'll be getting a pw50 carb for it being i can't find any other carb for it.
Thanks for the info.

[Preddy05]

hello again, I have another question. i had the bike running today for a little while and it didn't seem like it had as much power as it should. my grandpas lt50 pulls me around better than the little zinger will....does it need rebuilt? or is it something else? any help would be nice.
Thanks

[skippy]

if * still need a zinger carb.. i have one..