sray paint for plastics

[msrfrog]

has any one used the kylon fusion paint for plastic?

[Orangecnty250r]

Welcome!!

http://www.3wheelerworldforums.com/showthread.php?t=33850&highlight=Fusion+paint

Some guys here have had some success

[oddball3]

My brother sprayed his 300ex fenders white with the krylon fusion paint and so far its holding up pretty good. been through the mud, power washed, and no chips. It might chip getting hit with branches going through the woods and stuff. But his held out pretty good.

[Power_Ram100]

krylon fusion is what i use, havnt had any problems with it flaking off.

[monster 84r]

i was thinking about painting my bike with the stuff too. do * need to do anything to the plastics or just sand and spray?

[oddball3]

We just cleaned it good with rubbing alcohol, and rubbed it down with steel wool or a scotch bright pad. Then cleaned it again.

[bigredhead]

it should not flake off.. but hit a branch and it will obviously scratch eventually.

I"m considering doing mine red.. so scratches won't be as noticable.

[42F67N]

Its not bad ive done a few bikes with it the only bike its not holding up good on is my lil z50

[bigredhead]

It's all about the prep.

everything needs to be clean as a whisle.. wiped down with solvent and a CLEAN rag or betteryet paper towel. and then don't put any oily finger prints on it before you paint.

if you use a shop rag that has been in contact with grease or oil it will leave a film and paint will not stick properly.